%20 ₺3.000,00 ve üzeri alışverişlerde sepette %20 indirim →🐾 3D ürünlerimizin satışı nakittir. Kâr gelirinin bir kısmı ile sokak hayvanlarına mama ve ilaç desteği yapılmaktadır.
Fikirden ürüne, katman katman.ANKA COMPUTER · 3D baskı atölyesi · Bilgisayar ve aksesuar için HEPSİANKA mağazamız ↗
1 / 6
SONIC, NO AMS
Oyuncak ve Oyunlar

SONIC, NO AMS

It comes off 5 plates as 20 separate pieces and goes together in your hands. Every plate is a single colour, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model, and nothing has to be painted. Even the face is printed: the eyes, the pupi

₺550,00
Siparişinize özel üretilir

Tahmini teslim süresi: 1 gün. Renk seçimini sipariş onayında birlikte netleştiriyoruz.

Bu ürün hakkında soru sorun ↗
Parça sayısı
5 parça
Filament miktarı
105 gr
Tahmini baskı süresi
309 dakika
Teslim süresi
1 gün

Tasarımın detayları

It comes off 5 plates as 20 separate pieces and goes together in your hands. Every plate is a single colour, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model, and nothing has to be painted. Even the face is printed: the eyes, the pupils, the nose, the mouth and the pink of the ears are separate pieces. · Press the eyes into the face, then the two black pupils: the right pupil spans the white eye and the edge of the blue brow, so it goes in after the eyes. · Push the muzzle in under the eyes, then the nose and the mouth into the muzzle. · Press the pink plugs into the blue ears and the belly onto the body. · Push the arms into the shoulders and the gloves onto the arms. · Push the heels onto the legs. Rest each white strap on its heel from the front, then push the toe in: its pin goes into the heel and traps the strap. The full assembly guide (EN + ES, one picture per step) is in Documentation > Assembly Guide · Pull the tree supports off soon after printing, whole: once they take up moisture they get harder to remove. · No pin hole or plug socket has support. Clean the bearing faces: the face recesses of the body, the seat of the belly and the ends of the legs; the back of the eyes, the muzzle and the belly; the wrist of the right arm; the inner face of the straps. · The pupils, the nose and the mouth are small: tweezers help. · Push by hand, straight along the pin, in one go. If a pin is tight, warm it for a few seconds in your fingers and push again. Never lever the thin pink ears. · No glue is needed. If you want it permanent, one drop on each pin is enough. Printed one? Post a photo - and if you like it, a save helps more than anything else. Bu ürünün çizimi MakerWorld'den alınmıştır. Yapımcıya teşekkür ederiz. Bu ürün tasarımcının izniyle üretilmektedir.

3D baskının doğal katman izleri ürün yüzeyinde görülebilir. Ekran görüntüleri ile gerçek ürün rengi arasında küçük farklılıklar olabilir.